An introduction to heat transfer

By P. Lettieri, T. Elson. 2007

2,798 citations recorded by the source corpus.

View Paper: https://www.semanticscholar.org/paper/9d24e47927c297c26a06415d95cda542584b4d36

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Citations in the corpus

Heat Transfer Through Plasma-Sprayed Thermal Barrier Coatings in Gas Turbines: A Review of Recent Work (2009, methodology): “3 Predicted effect of temperature and pressure on the thermal conductivity of air in pores with a thickness of 100 nm; the experimental data of Incropera and DeWitt [64] for the conductivity of free air, which are also shown in the plot, were used as a base for the predictions.”
Numerical and experimental analysis of a horizontal ground-coupled heat pump system (2007, background): “The thermal diffusivity and the thermal conductivity of air are determined with dry air table properties [26] for 7.”
A General Cuboidal Element for Three-Dimensional Thermal Modelling (2010, background): “The resistive element commonly used in thermal equivalent networks is derived from a one-dimensional solution to the steady-state heat diffusion equation for zero internal heat generation [2].”
Effect of nanoparticle shapes on the heat transfer enhancement in a wavy channel with different phase shifts (2014, methodology): “Due to further code validation, the average Nusselt number and friction factor obtained from the present smooth channel for turbulent flow are also compared with the correlations of Dittus–Boelter and Blasius, respectively [35] as shown in Fig.”
Superconducting wind turbine generators (2010, background): “In order to thermally insulate the low temperature chamber from room temperature, the cryostat design needs to inhibit conduction and radiation heat transfer (142, 143).”
Convective heat transfer characteristics of magnetite nanofluid under the influence of constant and alternating magnetic field (2015, background): “In order to verify the accuracy of the transport properties measurements, primary tests have been carried out for DI-water and the results have been compared with that of Incropera [21].”
A critical review of cooling techniques in proton exchange membrane fuel cell stacks (2012, background): “[106] Incropera F, Dewitt P, Bergman TL, Lavine AS.”
Evolution and Modern Approaches for Thermal Analysis of Electrical Machines (2009, methodology): “The most common and useful convection correlations are even available in undergraduate textbooks on heat transfer [7]–[12].”