Materials science and engineering

By R. W. Cahn. Nature, 2023

1,283 citations recorded by the source corpus.

Subfields: Biomedical Engineering, General Materials Science, Materials Chemistry

View Paper: https://www.semanticscholar.org/paper/978f76c3683a56931114f026a9e3c2b82a3f20e0

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In General Materials Science

In Materials Chemistry

Citations in the corpus

Ultrasonic waves for materials evaluation in fatigue, thermal and corrosion damage: A review (2019, neutral): “Figure 1 [5] – Crack propagation stages More than 90% of metal structural failure during service is caused by fatigue failure [6].”
Phase separation of metastable CoCrFeNi high entropy alloy at intermediate temperatures (2016, background): “The equal-atomic alloy of CoCrFeNi is widely accepted as a thermally stable single-phase solid-solution HEA for its high mixing entropy [1-11].”
Van der Waals density functional study of the energetics of alkali metal intercalation in graphite (2014, background): “The polytype LiC6 /AαAβAγ/ has slightly higher energy than the most stable compound as illustrated in Fig 3, reflecting that it has also been observed at low temperatures [78].”
MODELING TECHNIQUES FOR DETERMINATION OF MECHANICAL PROPERTIES OF POLYMER NANOCOMPOSITES (2005, background): “Liang et al. showed the presence of an attractive interaction between SWNTs and epoxy polymer matrix [61].”
Characterization of Al-7075 metal matrix composites: a review (2019, neutral): “Also constituent materials are essentially insoluble in phase material [5].”
A review of current collectors for lithium-ion batteries (2021, methodology): “measured the 217 electrical resistivity of an Al wire using the four-probe technique [49].”
Effect of the build orientation on the mechanical properties and fracture modes of SLM Ti–6Al–4V (2014, background): “However these researches have been conducted on one build orientation only [16, 17].”
Load partitioning between ferrite and cementite during elasto-plastic deformation of an ultrahigh-carbon steel (2007, neutral): “…in situ matrix stress–strain curve, the plastic range of the experimental UHCS stress–strain curve was first fitted to a power-law hardening equation [69] : r T ¼ Ke n T ; ð2Þ where r T is the true stress, e T is the true strain, K is the strength coefficient and n is the strain-hardening exponent.”
Net Shape 3D Printed NdFeB Permanent Magnet (2016, background): “To stabilize the growth of the target magnetic phase Φ1, powder additives like Co, Zr and Ti play a significant role [26]; acting as catalyser for the nucleation of Nd2Fe14B and further influence the kinetics and thermodynamics of the solidification process.”