An investigation on kerf characteristics in abrasive waterjet cutting of layered composites

By Dinesh Shanmugam, Syed H. Masood. 2009

217 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Ecological Modeling, Ocean Engineering

View Paper: https://www.semanticscholar.org/paper/95315df9fba668e610cea37a19cf4bff72b3e2fd

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

1. T. Artaza
2. Amaia Alberdi

In Ecological Modeling

1. T. Artaza
2. Amaia Alberdi

In Ocean Engineering

1. T. Artaza
2. Amaia Alberdi

Citations in the corpus

• Composite Cutting with Abrasive Water Jet (2013, background): “There are a few studies that analyse the effect of input parameters on the quality of the cutting edge [3-5] or investigations that optimise process parameters for trimming CFRP materials with good quality [6].”
• Machinability of Nickel-Based Superalloy by Abrasive Water Jet Machining (2016, background): “Improper selection of cutting parameters may also lead to poor surface finish and kerf wall inclination [7, 8].”
• The new challenges of machining Ceramic Matrix Composites (CMCs): Review of surface integrity (2019, background): “Abrasive Water Jet (AWJ) machining has been shown to be a promising process to cut and shape hard ceramics such as SiC [72] and reinforced materials [73], [74].”