Electrical discharge machining characteristics of metal matrix composites

By Marek Rozenek, J. Kozak, L. Dabrowski, K. Łubkowski. 2001

157 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method (2007, methodology): “[7] used a metal matrix composite as workpiece material Time base”
Review of research work in sinking EDM and WEDM on metal matrix composite materials (2010, background): “reported experimental investigation for the effects of machining parameters (discharge current, pulse on-time, pulse off-time, and voltage) on the machining feed rate and surface roughness for machining of metal matrix composite AlSi7Mg/SiC and AlSi7Mg/Al2O3 [80].”
A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi method (2004, methodology): “[8] used a metal matrix composite as workpiece material and investigated the variation of machining feed rate and surface roughness with machining parameters.”
Modeling, simulation and parametric optimization of wire EDM process using response surface methodology coupled with grey-Taguchi technique (2010, methodology): “Rozenek et al. (2001) used a metal matrix composite as work piece material and investigated the variation of machining feed rate and surface roughness with machining parameters.”
A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix composites (2020, background): “The electrical conductivity and thermal conductivity of MMCs are lower than those of unreinforced matrix alloys, which decrease the MRR of WEDM [261].”