The barrel modules of the ATLAS semiconductor tracker
By A. Abdesselam, T. Akimoto, P. Allport, J. R. Alonso, B. Anderson, L. Andricek, F. Anghinolfi, R. Apsimon, G. Barbier, A. Barr and 254 more. 2006
169 citations recorded by the source corpus.
This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
Subfields: Nuclear and High Energy Physics, Radiation
View Paper: https://www.semanticscholar.org/paper/8e8a9378783f694f85e7bfc6531f90b64bbc50ca
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Nuclear and High Energy Physics
- Atlas Collaboration
- Cms Collaboration
- A. Boveia
- J. Butterworth
- Kyle Cranmer
- J. A. Aguilar-Saavedra
- A. Cooper-Sarkar
- L. Asquith
In Radiation
Citations in the corpus
- The ATLAS Experiment at the CERN Large Hadron Collider (2008, unknown): “The barrel modules [67] are mounted in rows of 12, on individual carbon-fibre brackets, as depicted in figure 4.”
- The ATLAS Inner Detector commissioning and calibration (2010, background): “Most modules [5, 6] consist of four silicon-strip sensors [7]; two sensors on each side are daisy-chained together to give 768 strips of approximately 12 cm in length.”
- The silicon microstrip sensors of the ATLAS semiconductor tracker (2007, methodology): “The assembled SCT modules are required to have no more than 1% of bad readout strips [5,6], and this places stringent demands on the strip quality of the individual sensors.”