Effects of Powder Characteristics on Electrodischarge Machining Efficiency

By Y. Tzeng, C. Lee. 2001

359 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/87df023c872a1e1025966567b02bfaa78f94b1aa

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

State of the art electrical discharge machining (EDM) (2003, background): “As a result, it increases the MRR, reduces the TWR and improves the sparking efficiency producing a strong corrosion resistant EDMed surface [90–92].”
Influences of Process Parameters on MRR Improvement in Simple and Powder-Mixed EDM of AA6061/10%SiC Composite (2015, background): “Tzeng and Lee [13] identified the effect of powder-mixed dielectric fluid Received February 14, 2014; Accepted May 7, 2014”
Study on the nano-powder-mixed sinking and milling micro-EDM of WC-Co (2011, methodology): “Tzeng and Lee [ 13 ] applied Al, Cr, Cu and SiC with working fluid and performed EDM on SKD-11 material.”
An experimental investigation of tool wear in electric discharge machining (2006, background): “It is also observed that increasing the average size of the suspended powder particles yields an increase in VW and VE while an increase in powder concentration leads to a decrease in VE [17].”
A review on current research trends in electrical discharge machining (EDM) (2007, background): “Tzeng and Lee [55] indicated that the greatest MRR is produced”
Comparative study of different dielectrics for micro-EDM performance during microhole machining of Ti-6Al-4V alloy (2010, methodology): “This particular concentration of additive in dielectrics has been selected based on past research studies on powdermixed dielectrics in EDM [16, 17 ].”
Effect of the powder concentration and dielectric flow in the surface morphology in electrical discharge machining with powder-mixed dielectric (PMD-EDM) (2008, methodology): “The authors also observed an increase of the discharging transitivity and frequency that promotes a more efficient and stable material removal process all over the processing zone [5, 25].”