Structural characteristics of fused deposition modeling polycarbonate material

By W. Smith, R. Dean. 2013

177 citations recorded by the source corpus.

Subfields: Automotive Engineering, Biomedical Engineering, Industrial and Manufacturing Engineering

View Paper: https://www.semanticscholar.org/paper/873822bd4cb89898c87fce570bc3fb7184076a6a

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Automotive Engineering

In Biomedical Engineering

In Industrial and Manufacturing Engineering

Citations in the corpus

Surface Roughness Quality and Dimensional Accuracy—A Comprehensive Analysis of 100% Infill Printed Parts Fabricated by a Personal/Desktop Cost-Effective FDM 3D Printer (2018, background): “Then, the thermoplastic filament material cools, solidifies within a tight time of roughly a few seconds (depending on the filament material) and then sticks to the surrounding material [16] [17].”
Experimental characterization of the mechanical properties of 3D-printed ABS and polycarbonate parts (2017, background): “These parameters were determined to be the most important and have been investigated by several other authors (Bellini & Güçeri 2003; Montero et al. 2001; Tymrak et al. 2014; Smith & Dean 2013; Hill & Haghi 2014).”
Fused Deposition Technique for Continuous Fiber Reinforced Thermoplastic (2017, background): “In relation to mechanical/structural performances, the polymeric materials usually employed, such as PLA, ABS, PC or Nylons present quite limited mechanical properties either coming from intrinsic low stiffness and strength of the polymer, either due to the defects which are invariably present in th”
Fused Deposition Modelling of Fibre Reinforced Polymer Composites: A Parametric Review (2021, background): “In the manufacturing process, “upright” and “on-edge” samples are more difficult to build compared to “flat” because of low attachment area to the printing bed and high stacking layers away from the heated bed that has low temperature to fuse the raster after printing [45].”
Recent Developments in Fused Deposition Modeling-Based 3D Printing of Polymers and Their Composites (2019, result): “The same finding was reported by Smith and Dean.143 Dorigato et al.,26 on the contrary, found that the material exhibited a greater strength in the vertical configuration due to the direction of the sample being pulled along the cross section of the deposited roads.”