Tribological performance of selective laser melted 316L stainless steel
By Hua Li, M. Ramezani, Ming Li, Chao Ma, Jyhwen Wang. Tribology International, 2018
139 citations recorded by the source corpus.
Abstract Selective laser melting (SLM) is a commonly used additive manufacturing technique for metallic parts. This paper investigates the effects of build-up directions and different test conditions on tribological behaviour of 316L stainless steel samples made by SLM. Sliding wear tests were conducted under different normal loads, temperatures and frequencies. The results showed that the effects of build-up direction on coefficient of friction (COF) and wear rate are not significant. At higher test temperatures, COF decreased significantly, while wear rate was maximum at 200 °C and then slightly decreased at higher temperatures due to oxide layers working as lubricants and protecting the samples from further loss of material. At higher contact pressures, wear rate was higher, but COF was not affected remarkably.
Subfields: Automotive Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/865ea95690440a1a228f2801a76795d44a804d7b
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Automotive Engineering
In Mechanical Engineering
Citations in the corpus
- Metal Binder Jetting Additive Manufacturing: A Literature Review (2020, background): “Powder bed fusion [18, 19, 21-23, 32-44] High accuracy Fully dense parts Good mechanical properties High cost (both machine depreciation and operation) Significant residual stress Support material required”
- Additive manufacturing of steels: a review of achievements and challenges (2020, background): “Mater Corros 70(9):1633–1645 [91] Li H, Ramezani M, Li M, Ma C, Wang J (2018) Tribo-”