Machinability analysis in drilling woven GFR/epoxy composites: Part I – Effect of machining parameters
By U. Khashaba, I. El-Sonbaty, A. Selmy, A. Megahed. 2010
253 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/818faa08d007af1c3ee74b6474458f8e582d17b9
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- U. Khashaba
- G. Prusty
- Dzung Viet Dao
- Huaizhong Li
- Vadim V. Silberschmidt
- A. Roy
- Amir Lotfi
- V. Phadnis
In Electrical and Electronic Engineering
- G. Prusty
- Dzung Viet Dao
- Huaizhong Li
- Amir Lotfi
- U. Khashaba
- Vadim V. Silberschmidt
- A. Roy
- V. Phadnis
In Mechanical Engineering
- G. Prusty
- Dzung Viet Dao
- Huaizhong Li
- Amir Lotfi
- U. Khashaba
- Vadim V. Silberschmidt
- A. Roy
- V. Phadnis
Citations in the corpus
- Drilling of polymer matrix composites: A review (2013, background): “Khashaba et al.3 reported that surface roughness in drilling woven FRP composites was slightly increased with increasing the feed, while no clear effect of the cutting speed is observed.”
- Natural fiber–reinforced composites: A review on material, manufacturing, and machinability (2019, result): “Most of the results have proved that at higher spindle speeds, lower feed rates, lesser drill diameters, and point angles, the removal of fibers from the matrix is completely sheared resulting in relatively good surface finish.(131) Lotfi et al.”
- Drilling in carbon/epoxy composites: Experimental investigations and finite element implementation (2013, methodology): “Various experimental studies were carried out in the past [4, 7, 14, 20-24] to optimise the machining parameters in order to obtain better performance in drilling of CFRP composites.”