Rheology of fresh concrete: from measurements to predictions of casting processes

By Nicolas Roussel. 2007

230 citations recorded by the source corpus.

Subfields: Building and Construction, Fluid Flow and Transfer Processes, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/81259ccb9dd1711451701548aec65cc995d8c331

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Building and Construction

In Fluid Flow and Transfer Processes

In Mechanical Engineering

Citations in the corpus

Effect of Coarse Particle Volume Fraction on the Yield Stress and Thixotropy of Cementitious Materials (2008, background): “The study of Hammer and Wallevik [23] suggests that in some cases (it may depend strongly on the cement paste composition) this may be true only if the aggregates are larger than 0.25 to 0.5 mm; in such cases, our approach would then be valid for SCC only if the suspending yield stress fluid include”
Thixotropic structural build-up of cement-based materials: A state-of-the-art review (2021, background): “Thixotropy has a significant effect on the formwork pressure decay, inter-layer bonding of concrete casting or 3D printing, pumping reinitiation after (un)expected rest and many more [10,26,29].”
Yield Stress During Setting of Cement Pastes From Penetration Tests (2009, methodology): “Visco^ plastic fluid simulations A 3D Binghammodel is used to describe the tested fluid behaviour [11,12].”
Flowability of fibre-reinforced concrete and its effect on the mechanical properties of the material (2010, background): “The viscosity of the material will only play a role on the time needed to obtain a horizontal surface [21,22].”
Influence of yield stress and compressive strength on direct shear behaviour of steel fibre-reinforced concrete (2012, background): “It has been reported that low yield stress provides good placeability of concrete [23–27].”
Properties of fresh and hardened concrete (2011, background): “), yield stress is the most important parameter for formwork filling in practice [1,7].”