Digital Equalization of Chromatic Dispersion and Polarization Mode Dispersion
By Ezra Ip, Joseph M. Kahn. Journal of Lightwave Technology, 2007
326 citations recorded by the source corpus.
Subfields: Electrical and Electronic Engineering
View Paper: https://www.semanticscholar.org/paper/7444239ce4a6c09314ab6bf77e838845ff57a4b6
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Electrical and Electronic Engineering
- Joseph M. Kahn
- Ezra Ip
- Seb J. Savory
- Irshaad Fatadin
- David J. Ives
- Sercan Ö. Arik
- Daulet Askarov
- Neda Cvijetic
Citations in the corpus
- OFDM for Next-Generation Optical Access Networks (2012, background): “be observed that prior to 2007–2008, the highest speed commercial data converter operated in the 20 Gs/s range, and it was an ADC [87].”
- Blind Equalization and Carrier Phase Recovery in a 16-QAM Optical Coherent System (2009, methodology): “A 5th order low pass Bessel filter with a 3-dB bandwidth of 80% the symbol-rate was also included in the simulation as the antialiasing filter [ 5 ].”
- Feedforward Carrier Recovery for Coherent Optical Communications (2007, methodology): “PLLs are sensitive to propagation delay inside Manuscript received November 27, 2006; revised May 10, 2007.”
- Compensation of Dispersion and Nonlinear Impairments Using Digital Backpropagation (2008, methodology): “However, systems at 50 Gb/s also suffer from PMD for realistic transmission distances [2].”
- Recent advances in coherent optical communication (2009, unknown): “The concept of polarization MIMO can be extended to describe PMD by a time-dependent 22 channel matrix [26, 30 ],”
- Effect of Mode Coupling on Signal Processing Complexity in Mode-Division Multiplexing (2013, background): “We neglect here the GD spread due to PMD, which is much smaller than that due to MD [35], [50]–[52].”
- Fiber Impairment Compensation Using Coherent Detection and Digital Signal Processing (2010, background): “1) Equalizer Length and Oversampling: It was shown in [13] that when the receiver A/D is well modeled by a fifth-order Butterworth filter response with a 3-dB cutoff frequency equal to 40% of the symbol rate, a minimum oversampling rate of 3/2 is necessary to mitigate against sampling time offset, a”