Effect of feed rate, workpiece hardness and cutting edge on subsurface residual stress in the hard turning of bearing steel using chamfer + hone cutting edge geometry

By J. Hua, R. Shivpuri, Xiao-Yin Cheng, V. Bedekar, Y. Matsumoto, F. Hashimoto, T. Watkins. 2005

194 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, result): “A summary of previous work on residual stresses in hard turning was presented in a recent work (Hua et al., 2005), which consolidated the results of prior investigators in a single table reporting the effect of tool geometry, cutting process parameters, and material hardness.”
Comparison of tool life between ceramic and cubic boron nitride (CBN) cutting tools when machining hardened steels (2009, background): “However, Chou et al.(2002), Ozel and Nadgir (2002); Ozel and Karpat (2005), Poulachon et al.(2001), Poulachon et al.(2004), Luo et al.(1999), Hua et al.(2005); Theile t al.”
Effect on cutting force in turning hardened tool steels with cubic boron nitride inserts (2007, background): “Much research has been done in high-speed turning of hardned steels such as AISI 52100 bearing steel [1–3], AISI”
Optimization of surface roughness and cutting temperature in high-pressure coolant-assisted hard turning using Taguchi method (2016, background): “In turning hardened steels, the rise in temperature is due to the higher specific cutting energy associated with increased hardness of material [35].”