On the difference in material structure and fatigue properties of nylon specimens produced by injection molding and selective laser sintering
By B. Hooreweder, David Moens, R. Boonen, Jean-Pierre Kruth, P. Sas. 2013
189 citations recorded by the source corpus.
Subfields: Automotive Engineering, Industrial and Manufacturing Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/69531bd3dceb9e33d7e16fab88d217d4fa9f3827
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Automotive Engineering
- Amir Abbas Zadpoor
- Trevor J. Watt
- Gerwin Smit
- D. Bourell
- Juan Sebastian Cuellar
- B. Fulcher
- Lauren Safai
- D. K. Leigh
In Industrial and Manufacturing Engineering
- Amir Abbas Zadpoor
- Trevor J. Watt
- Gerwin Smit
- D. Bourell
- Juan Sebastian Cuellar
- B. Fulcher
- Lauren Safai
- D. K. Leigh
In Mechanical Engineering
Citations in the corpus
- A review of the fatigue behavior of 3D printed polymers (2019, background): “Aside from density, reference [67] studied the differences in the fatigue life between notched and un-notched injection molded and 3D printed PA12 parts [64], where the 3D printed parts were built in the Vert-x and Z-x directions (Fig.”
- Performance Limitations in Polymer Laser Sintering (2014, result): “Rapid cooling in IM also results in reduced crystallinity compared to LS parts, as discussed by Hooreweder et al. (2013).”