The influence of rake angle, cutting feed and cutting depth on residual stresses in hard turning

By P. Dahlman, F. Gunnberg, M. Jacobson. 2004

217 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Materials Chemistry, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/67468e181e2c9bde6eff34bd6a8e4d52d9b39dd9

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. I. S. Jawahir
2. W. Li
3. José C. Outeiro
4. Yuebin B. Guo
5. Rachid M'Saoubi
6. O. Dillon
7. Dilbag Singh
8. P. Venkateswara Rao

In Materials Chemistry

1. I. S. Jawahir
2. José C. Outeiro
3. Rachid M'Saoubi
4. O. Dillon
5. Yuebin B. Guo

In Mechanical Engineering

1. I. S. Jawahir
2. W. Li
3. O. Dillon
4. José C. Outeiro
5. Rachid M'Saoubi
6. Yuebin B. Guo
7. Dilbag Singh
8. P. Venkateswara Rao

Citations in the corpus

• SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS (2009, background): “FIGURE 6 RS distribution in hard turning AISI 52100 with different rake angle (Dahlman et al., 2004).”
• A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, background): “The influence of tool rake angle, feed rate and depth of cut on residual stresses in PCBN hard face turning of AIS 52100 was investigated by Dahlman et al. (2004). Their results indicate that higher compressive stresses are generated by increasing the feed rate and from the use of a negative rake an”
• A surface roughness prediction model for hard turning process (2007, background): “[3] have conducted the study on the influence of rake angle, cutting speed and cutting depth on residual stresses in hard turning.”