Residual stresses in laser direct metal deposited Waspaloy
By R. Moat, A. Pinkerton, Lin Li, P. J. Withers, M. Preuss. 2011
195 citations recorded by the source corpus.
Subfields: Computational Mechanics, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/6637ebd195da72aaf2a0b54533b7c6fc411d8afd
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Computational Mechanics
In Mechanical Engineering
- Stewart W. Williams
- Filomeno Martina
- Moataz M. Attallah
- Paul A. Colegrove
- L. Carter
- Iain Todd
- Z. Pei
- Sjoerd O. van der Veen
Citations in the corpus
- Reduction of micro-cracking in nickel superalloys processed by Selective Laser Melting: A fundamental alloy design approach (2015, background): “Micro-cracking and thermal stresses have been reduced through control of laser scanning parameters and heated platforms [1,4–7].”
- Additive manufacturing of Ni-based superalloys: The outstanding issues (2016, unknown): “Experimental measurement of residual stress has been carried out by the hole drilling method (20, 21), deflection method (14, 22), X-ray diffraction method (12, 14), contour method (15, 23) and neutron diffraction (15, 23).”
- Residual stress evaluation in selective-laser-melting additively manufactured titanium (Ti-6Al-4V) and inconel 718 using the contour method and numerical simulation (2018, methodology): “Numerical simulation [10, 11] as well as experimental techniques [5, 6, 12, 13] have been used to”
- Metal Binder Jetting Additive Manufacturing: A Literature Review (2020, background): “[20, 45-55] Large build volume possible Graded materials capability Good mechanical properties Ability to build on or repair parts High cost (both machine depreciation and operation) Low resolution Significant residual stress Relatively rough surface Several excellent review papers…”
- Residual stress of as-deposited and rolled wire+arc additive manufacturing Ti–6Al–4V components (2016, result): “These measurements are consistent with those reported on steel WAAM structures,[7],[8] and on WAAM Ti– 6Al–4V structures,[32] but are different from those reported by Moat et al.[33] on laser sintered structures.”
- A comparative study of additive manufacturing techniques: Residual stress and microstructural analysis of CLAD and WAAM printed Ti–6Al–4V components (2016, unknown): “Additive manufacturers [13,5,14,15] have been trying to eliminate these problems by extensive study of AM process parameters targeting simultaneously the economical and environmental benefits of additive over conventional manufacturing.”