Machining of an aluminum/SiC composite using diamond inserts

By Caroline J.E Andrewes, Hsi-Yung Feng, W. M. Lau. 2000

206 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Effect of machining parameters on surface roughness and tool wear for 7075 Al alloy SiC composite (2010, background): “Andrewes et al. [ 14 ] reported that when machining”
Evaluation of machining performance of MMC with PCBN and PCD tools (2005, background): “Studies on tool wear and surface integrity have found that ool wear is predominantly caused by abrasion of the hard einforcement particles in the MMCs [1–12].”
A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix composites (2020, background): “[46] observed a faster flank wear rate on a CVD diamond insert than on a PCD insert, but that faster wear rate could be reduced by securing stronger adhesion between the carbide substrate and diamond coating.”
Machinability issues in turning of Al-SiC (10p) metal matrix composites (2008, background): “Andrews et al. (2000) [ 8 ] compared the performance of”
Prediction of cutting forces in machining of Metal Matrix Composites (2006, background): “(2) Experimental studies on the performance of PCD tools, machined surface, and optimization of cutting parameters, tool geometry and work piece compositions [1, 4, 9-22].”