Experimental investigations of cutting parameters influence on cutting forces and surface roughness in finish hard turning of MDN250 steel
By D. I. Lalwani, N. Mehta, Pramod Kumar Jain. 2008
480 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/61517486bf37fc83be82e0e6fd4e653f6d86068d
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
- Mozammel Mia
- Song Zhang
- Xiaoli Zhu
- Yuanwei Wang
- Nikhil Ranjan Dhar
- T. Ding
- E. Turkes
- Suleyman Neseli
In Electrical and Electronic Engineering
In Mechanical Engineering
- Mozammel Mia
- Song Zhang
- Xiaoli Zhu
- Yuanwei Wang
- Nikhil Ranjan Dhar
- T. Ding
- E. Turkes
- Suleyman Neseli
Citations in the corpus
- Optimization of surface roughness and cutting temperature in high-pressure coolant-assisted hard turning using Taguchi method (2016, background): “12 mm/rev) [36, 38], and material hardness at level 1 (40 HRC) [3].”
- Optimization of tool geometry parameters for turning operations based on the response surface methodology (2011, background): “[9] studied the effect of cutting parameters in turning on cutting forces and surface roughness.”
- Optimization of surface roughness, cutting force and tool wear of nitrogen alloyed duplex stainless steel in a dry turning process using Taguchi method (2014, unknown): “in various alloys [22–28].”
- Empirical models and optimal cutting parameters for cutting forces and surface roughness in hard milling of AISI H13 steel (2010, background): “[ 6 ]. There has been a considerable amount of work reported in the literatures about the effects of the cutting parameters on cutting forces and surface roughness in turning.”