Hard turning: AISI 4340 high strength low alloy steel and AISI D2 cold work tool steel

By J. G. Lima, R. F. Ávila, Alexandre M. Abrão, M. Faustino, J. Paulo Davim. 2005

265 citations recorded by the source corpus.

Subfields: Materials Chemistry, Mechanical Engineering, Mechanics of Materials

View Paper: https://www.semanticscholar.org/paper/5d8998265d56c3be38703b3947f19fad4cc5c914

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Materials Chemistry

1. Yigit Karpat
2. V. Gaitonde
3. Luís Figueira
4. Y. Şahin
5. R. Suresh
6. G. Samuel
7. Engin Nas
8. M. Karabatak

In Mechanical Engineering

1. V. Gaitonde
2. S. Basavarajappa
3. Y. Şahin
4. G. Samuel
5. R. Suresh
6. Fuat Kara
7. Engin Nas
8. M. Karabatak

In Mechanics of Materials

1. Y. Şahin
2. V. Gaitonde
3. R. Suresh
4. G. Samuel
5. Yigit Karpat
6. J. Paulo Davim
7. Tugrul Özel
8. S. Basavarajappa

Citations in the corpus

• Comparison of tool life between ceramic and cubic boron nitride (CBN) cutting tools when machining hardened steels (2009, background): “Similar results were obtained with previous works carried out by Lima et al.(2005), Jang et al.(2000); Sahin (2006), Benga and Abrao (2003), Chou et al.(2002), Yang and Tarng (1998), Davim and Figueira (2006).”
• Effect of machinability, microstructure and hardness of deep cryogenic treatment in hard turning of AISI D2 steel with ceramic cutting (2020, methodology): “[34] Lima JG, Avilla RF, Abroa AM, Faustino M, Dawim JP.”
• Analysis of Machinability During Hard Turning of Cold Work Tool Steel (Type: AISI D2) (2009, background): “[ 25 ] studied the effects of cutting speed, feed rate and depth of cut on cutting forces, tool wear, and surface roughness in hardened AISI 4340 high strength low alloy steel and AISI D2 cold work tool steel materials.”
• Modelling of surface finish and tool flank wear in turning of AISI D2 steel with ceramic wiper inserts (2007, methodology): “Lima et al. [ 19 ] presented results for hard turning of AISI D2 tool steel (58 HRC) using mixed alumina ceramic inserts with conventional nose radius geometry and reported that surface finishes as good as that produced by cylindrical grinding were attainable.”
• Some studies on hard turning of AISI 4340 steel using multilayer coated carbide tool (2012, background): “1 to 30 lm), hard (>2500 VHN) coatings can reduce tool wear and improve tool life and also productivity [15].”