513 Mbit/s Visible Light Communications Link Based on DMT-Modulation of a White LED
By J. Vucic, C. Kottke, Stefan Nerreter, Klaus-Dieter Langer, J. Walewski. Journal of Lightwave Technology, 2010
505 citations recorded by the source corpus.
Subfields: Electrical and Electronic Engineering
View Paper: https://www.semanticscholar.org/paper/5ad9db2e7dee784f73d68f17512fbb282f4708d4
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Electrical and Electronic Engineering
- Harald Haas
- Raed Mesleh
- Hany Elgala
- Svilen Dimitrov
- Prasant Mohapatra
- Parth H. Pathak
- Xiaotao Feng
- Pengfei Hu
Citations in the corpus
- Visible Light Communication, Networking, and Sensing: A Survey, Potential and Challenges (2015, methodology): “Authors in [46] also used QAM on DMT subcarriers to achieve a link rate of 513 Mbps, however, it does not address the issue of LED dimming.”
- Indoor optical wireless communication: potential and state-of-the-art (2011, methodology): “The maximum measured data rate for a VLC system using bluechip LEDs is reported in [ 4 ], where a modified version of the classical orthogonal frequencydivision multiplexing (OFDM) modulation technique is considered to achieve data rates higher than 500 Mb/s.”
- Visible-Light Communications Using a CMOS-Controlled Micro-Light- Emitting-Diode Array (2012, unknown): “using white LEDs [5].”
- Information Rate of OFDM-Based Optical Wireless Communication Systems With Nonlinear Distortion (2013, background): “In general, practical indoor O-OFDM system implementations aim to reduce the computational effort only to the IFFT/FFT operations, while the additional system parameters are computed offline and stored in look-up tables, for the sake of the realization of high data rate optical links [31].”
- A Gigabit/s Indoor Wireless Transmission Using MIMO-OFDM Visible-Light Communications (2013, methodology): “As is discussed in [6], illuminance is an important design parameter, and a level of ∼ 1000 lux is typical for indoor lighting.”
- LED Based Indoor Visible Light Communications: State of the Art (2015, unknown): “Symmetrical clipping of both high and low peaks has been employed successfully in [89], [91].”