Modelling the machining parameters of wire electrical discharge machining of Inconel 601 using RSM

By M. Hewidy, T. A. El-Taweel, M. El-Safty. 2005

362 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/5abbf4397c9b98d9385be2e9800e8fce51e852b3

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

Mathematical Modeling for Radial Overcut on Electrical Discharge Machining of Incoloy 800 by Response Surface Methodology (2014, background): “…composite design; Response surface methodology; 1 Introduction Nickel base super alloys are widely used in high temperature and high pressure applications such as gas turbines, electric power generation equipment, nuclear reactors and high temperature chemical vessels (Hewidy et al. (2005)).”
Turbomachinery component manufacture by application of electrochemical, electro-physical and photonic processes (2014, neutral): “However whereas standard EDM uses a dielectric ﬂuid, AS systems generally employ a solution of highly conductive sodium silicate (water glass (cid”
Investigations into the effect of tool shapes with size factor consideration in sink electrical discharge machining (EDM) process (2009, result): “Thus, the MRR as well as TWR increase with discharge current, which closely agree with the previous investigations [33, 34].”
Multi-response optimization of EDM with Al–Cu–Si–TiC P/M composite electrode (2009, background): “It is asserted that a tendency to have runs of positive and negative residuals indicates the existence of certain correlations [28–31].”
Effects of process parameters on material removal rate in WEDM (2009, methodology): “2009 Purpose: In this paper, the effects of various process parameters of WEDM like pulse on time (TON), pulse off time (TOFF), gap voltage (SV), peak current (IP), wire feed (WF) and wire tension (WT) have been investigated to reveal their impact on material removal rate of hot die steel (H-11) usi”
Application of Taguchi, ANFIS and grey relational analysis for studying, modeling and optimization of wire EDM process while using gaseous media (2014, background): “[5] studied on mechanical properties and machinability of Al/SiC.”
Parametric modeling and optimization for wire electrical discharge machining of Inconel 718 using response surface methodology (2015, positive): “[32] developed mathematical models for correlating the various machining parameters with volumetric metal removal rate, wear ratio, and surface roughness based on the response surface methodology during WEDM of Inconel 601 using copper wire.”
Multi-response optimization of process parameters based on response surface methodology for pure titanium using WEDM process (2013, methodology): “The same trend was observed by researchers [19, 23, 24].”