A review of developments towards dry and high speed machining of Inconel 718 alloy

By D. Dudzinski, A. Devillez, A. Moufki, D. Larrouquere, V. Zerrouki, J. Vigneau. 2004

754 citations recorded by the source corpus.

Subfields: Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/588903be84e9928402a769ccfe9dab31a4149649

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Electrical and Electronic Engineering

1. I. S. Jawahir
2. Y. Kaynak
3. José C. Outeiro
4. Rachid M'Saoubi
5. F. Bedir
6. Knut Sørby
7. I. Al-Samarrai
8. Stephen T. Newman

In Mechanical Engineering

1. I. S. Jawahir
2. Y. Kaynak
3. O. Dillon
4. José C. Outeiro
5. Rachid M'Saoubi
6. Stephen T. Newman
7. Alborz Shokrani
8. GurRaj Singh

Citations in the corpus

• Wear resistance investigation of titanium nitride-based coatings (2015, background): “Consequently, combining these two cutting methods was inevitable and has resulted in the evolution of dry high-speed cutting systems [46-47].”
• A review of surface integrity in machining and its impact on functional performance and life of machined products (2008, methodology): “Several SI problems that exist after machining nickel-based superalloys are reported in the literature, including surface tearing, cavities, cracking, metallurgical transformation, plastic deformation, increased microhardness, increased surface roughness and the formation of tensile residual stresse”