A comparison of cryogenic and high pressure emulsion cooling technologies on tool life and chip morphology in Ti-6Al-4V cutting
By M. Bermingham, S. Palanisamy, D. Kent, Mathew S. Dargusch. 2012
228 citations recorded by the source corpus.
Subfields: Civil and Structural Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/51d7252ded3b49ef48990ca5bfd3c8f4be5c846b
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Civil and Structural Engineering
In Electrical and Electronic Engineering
- Guy Littlefair
- Mozammel Mia
- I. Al-Samarrai
- Stephen T. Newman
- A. Pramanik
- Nikhil Ranjan Dhar
- Alborz Shokrani
- A. A. Khan
In Mechanical Engineering
- Guy Littlefair
- Mozammel Mia
- I. Al-Samarrai
- Stephen T. Newman
- A. Pramanik
- Nikhil Ranjan Dhar
- Alborz Shokrani
- A. A. Khan
Citations in the corpus
- Machining of Titanium Alloy (Ti-6Al-4V)—Theory to Application (2015, background): “Flood cooling is commonly/conventionally applied to reduce heat and induce lubricant into the tool-chip and tool-workpiece interfaces (Bermingham et al., 2012).”
- Optimization of surface roughness and cutting temperature in high-pressure coolant-assisted hard turning using Taguchi method (2016, background): “A comparative advantage of HPC over cryogenic cooling, in turning of Ti-6Al-4V, was found in promoting tool life [29].”
- Hybrid cryogenic MQL for improving tool life in machining of Ti-6Al-4V titanium alloy (2019, background): “[15], noted that controlling heat generation by controlling cutting parameters is more significant than heat removal from the process in machining Ti-6Al-4V alloy.”