Material removal rate and electrode wear study on the EDM of silicon carbide

By C. Luis, I. Puertas, G. Villa. 2005

342 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/509a9f7a0775485a0d225b452a3d28f5aba1a2d0

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

In Electrical and Electronic Engineering

In Mechanical Engineering

Citations in the corpus

Review of research work in sinking EDM and WEDM on metal matrix composite materials (2010, background): “The workpiece and the electrode are separated by a specific small gap, the so-called ‘spark gap’, and pulsed discharges occur in this gap filled with an insulating medium [5–8].”
A review on current research trends in electrical discharge machining (EDM) (2007, methodology): “This technique has been developed in the late 1940s [2] where the process is based on removing material from a part by means of a series of repeated electrical discharges between tool called the electrode and the work piece in the presence of a dielectric fluid [3].”
INVESTIGATING THE EFFECTS OF EDM PARAMETERS ON SURFACE INTEGRITY, MRR AND TWR IN MACHINING OF Ti–6Al–4V (2012, background): “Pulse on time is the duration of time that current is allowed to flow per cycle and open circuit voltage is the voltage between workpiece and tool electrode before pulse generation (Luis et al., 2005).”
Reducing electrode wear ratio using cryogenic cooling during electrical discharge machining (2009, background): “Luis et al. [ 13 ]i nvestigated the influence of I, ton, η, V ,a ndP on MRR and EW. Puertas et al. [5] in their report on “Analysis of the influence of EDM parameters on surface quality, MRR and EW of WC– Co” considered the factors I, ton, η .E ffect ofI, ton ,a ndVon overcut, EWR and MRR was repor”
Modeling and analysis of the effects of machining parameters on the performance characteristics in the EDM process of Al2O3+TiC mixed ceramic (2008, background): “Luis et al. [ 12 ] investigated the influence of machining parameters on the material removal rate and electrode wear of siliconised or reaction-bonded silicon carbide (SiSiC) in the die-sinking EDM.”