Influence of machining parameters on the machinability of particulate reinforced Al/SiC–MMC

By A. Manna, B. Bhattacharayya. 2005

166 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/50219990f3fb54bde7fcb245054b6bd592c7ef76

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. Guojian He
2. Sudhir Kumar
3. Lin Gu
4. S. Das
5. Jipeng Chen
6. Rajesh Kumar Bhushan

In Electrical and Electronic Engineering

1. Guojian He
2. Lin Gu
3. Jipeng Chen
4. Sudhir Kumar
5. S. Das
6. Rajesh Kumar Bhushan

In Mechanical Engineering

1. Guojian He
2. Lin Gu
3. Jipeng Chen
4. Sudhir Kumar
5. S. Das
6. Rajesh Kumar Bhushan

Citations in the corpus

• A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix composites (2020, background): “Manna and Bhattacharayya [54] conducted a series of experiments and found that the cut- ting force was smaller at lower cutting speeds, whereas the feed force was larger at lower cutting speeds than at higher cutting speeds.”
• Effect of machining parameters on surface roughness and tool wear for 7075 Al alloy SiC composite (2010, methodology): “Results indicated that cutting speed, feed rate, and depth of cut are having equal influence on the surface roughness characteristics, i.e., Ra and Rt. High speed, low feed rate, and low depth of cut was recommended for achieving better surface finish during turning of Al/SiC-MMC using tungsten carb”