Effect of tube diameter on boiling heat transfer of R-134a in horizontal small-diameter tubes

By S. Saitoh, H. Daiguji, E. Hihara. 2005

236 citations recorded by the source corpus.

View Paper: https://www.semanticscholar.org/paper/4d78c75a40b6a53646953ec1cb959203380105c8

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Mechanical Engineering

Citations in the corpus

Microchannel size effects on local flow boiling heat transfer to a dielectric fluid (2008, background): “[18] experimentally investigated the boiling heat transfer of refrigerant R-134a flow in three horizontal tubes of diameter 0.”
Measurements and High-Speed Visualizations of Flow Boiling of a Dielectric Fluid in a Silicon Microchannel Heat Sink † (2006, background): “Results obtained in a study of flow boiling of R-134a in tubes of three different diameters (0.5, 1.1, 3.1 mm) by Saitoh et al. (2005) showed that the contribution of forced convective heat transfer to the overall heat transfer decreases with decreasing tube diameter.”
Universal approach to predicting saturated flow boiling heat transfer in mini/micro-channels - Part II. Two-phase heat transfer coefficient (2013, unknown): “(2005) [51] C, single, H Stainless steel 0.”
Refrigerant flow boiling heat transfer in parallel microchannels as a function of local vapor quality (2008, background): “[20] found similar behavior to conventional tubes with a trend of increasing heat transfer at higher vapor quality.”
A composite heat transfer correlation for saturated flow boiling in small channels (2009, background): “[29] R-134a circular (N = 1) horizontal, D = 0.”
Effects of channel dimension, heat flux, and mass flux on flow boiling regimes in microchannels (2009, background): “Lin et al. (2001), Saitoh et al. (2005) studied the effects of mass flux and channel diameter on boiling heat transfer coefficients for refrigerants in small channels.”
Effects of heat flux, mass flux, vapor quality, and saturation temperature on flow boiling heat transfer in microchannels (2009, background): “Similar results were reported by Saitoh et al. (2005).”
Universal approach to predicting saturated flow boiling heat transfer in mini/micro-channels – Part I. Dryout incipience quality (2013, unknown): “(2005) [51] C, single, H Stainless steel 0.”
Review and Comparative Analysis of Studies on Saturated Flow Boiling in Small Channels (2008, background): “An array of circular copper minichannels with an inside diameter of 2 mm was tested with the fluid R134a.”