The influence of cutter orientation and workpiece angle on machinability when high-speed milling Inconel 718 under finishing conditions

By D. Aspinwall, R. Dewes, E. Ng, C. Sage, S. Soo. 2007

138 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/3a868a7ed24be4e68c3a6d70646fb1e811360955

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. W. Li
2. Yuebin B. Guo
3. I. S. Jawahir
4. Tugrul Özel
5. Y. Kaynak

In Electrical and Electronic Engineering

1. W. Li
2. I. S. Jawahir
3. Yuebin B. Guo
4. Tugrul Özel
5. Y. Kaynak

In Mechanical Engineering

1. W. Li
2. I. S. Jawahir
3. Yuebin B. Guo
4. Tugrul Özel
5. Y. Kaynak

Citations in the corpus

• Machinability of Nickel-Based Superalloy by Abrasive Water Jet Machining (2016, background): “The major causes due to conventional machining of nickel alloys are surface defects due to repeated force in milling [14, 15], residual stress due to cutting tool–work piece orientation [16] and variation in surface finish [17].”
• SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS (2009, background): “FIGURE 24 Effect of different cutter orientations/workpiece tilt angle on residual stress (Aspinwall et al., 2007).”