Examination of wire electrical discharge machining of Al2O3p/6061Al composites

By B. Yan, H. C. Tsai, F. Huang, L.C. Lee. 2005

201 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Determination of material removal rate in wire electro-discharge machining of metal matrix composites using dimensional analysis (2010, background): “In addition, it has also been observed and reported by many other researchers [24, 29, 30, 34 ].”
State-of-the-art of surface integrity in machining of metal matrix composites (2019, background): “Figure 41 SEM micrographs of surface morphology after EDM: the Al/SiC composite (a) and the Al/Al2O3 composite (b) [95,96]”
Multi-response optimization of process parameters based on response surface methodology for pure titanium using WEDM process (2013, background): “In other words, double sparking or re-sparking can cause poor surface finish since only the initial phase sparks contributed to the material removal, while the following sparks were poorly distributed along the surface, debris and removed particles [27, 28].”
Review of research work in sinking EDM and WEDM on metal matrix composite materials (2010, background): “investigated machining of Al2O3p/6061Al composite on WEDM [82].”