Study of tool wear and surface roughness in machining of homogenised SiC-p reinforced aluminium metal matrix composite

By E. Kılıçkap, Ö. Çakır, M. Aksoy, A. İnan. 2005

257 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Investigation of Mechanical Properties of Aluminium 6061-Silicon Carbide, Boron Carbide Metal Matrix Composite (2018, unknown): “It is recommended that the coated carbide cutting tool with high cutting speed and low feed rate produces a better surface finish [13].”
An FEM investigation into the behavior of metal matrix composites: tool-particle interaction during orthogonal cutting (2007, background): “It was also reported that flank wear increases with the increase of speed [30, 31] and at high speeds, chipping of cutting edge becomes prominent [31].”
A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix composites (2020, background): “wear mechanism and there is almost no evidence of chemical wear; moreover, tool wear occurs on the flank face and the cutting speed is found to be the most influential parameter [51].”
Processing issues, machining, and applications of aluminum metal matrix composites (2018, methodology): “Coating of the tool([268]) or use of wiper tool reduces the tool wear significantly([244]) while, heat treatment of MMCs increases tool wear and thus reduces the tool life.([268]) Quan and Ye([257]) observed that wiper cutting edge geometry imparts”