Critical assessment and numerical comparison of electro-thermal models in EDM

By Swee Hock Yeo, W. Kurnia, P. Tan. 2008

199 citations recorded by the source corpus.

Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/32eff68834d4a351334a29d9a0dde75abe71e6ac

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Biomedical Engineering

1. P. Brahmankar
2. N. Patil

In Electrical and Electronic Engineering

1. P. Brahmankar
2. N. Patil

In Mechanical Engineering

1. P. Brahmankar
2. N. Patil

Citations in the corpus

• Determination of material removal rate in wire electro-discharge machining of metal matrix composites using dimensional analysis (2010, result): “Recently, Yeo et al. [ 9 ] compared five EDM models from Snoeys, Van Dijck, Beck, Jilani and DiBitonto in terms of the temperature distribution, crater geometry and material removal at the cathode.”
• Influence of discharge energy on machining characteristics in EDM (2012, methodology): “A plasma zone is formed at temperatures as high as 40,000°C, while the workpiece surface reaches 10,000°C [7].”