The early hydration of Ordinary Portland Cement (OPC): An approach comparing measured heat flow with calculated heat flow from QXRD

By D. Jansen, F. Goetz-Neunhoeffer, B. Lothenbach, Jürgen Neubauer. 2012

372 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Earth-Surface Processes, Ocean Engineering

View Paper: https://www.semanticscholar.org/paper/2c07612a286fb501679a5d43992e02b12e988af6

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

In Earth-Surface Processes

In Ocean Engineering

Citations in the corpus

Characteristics and application potential of municipal solid waste incineration (MSWI) bottom ashes from two waste-to-energy plants (2015, background): “According to [66,67], these peaks refer to the dissolution of C3A and the precipitation of ettringite, which is defined as ‘‘sulphate depletion peak’’ because of the participation of sulphate to the reaction.”
Rietveld Quantitative Phase Analysis of OPC Clinkers, Cements and Hydration Products (2012, positive): “This methodology has been applied to anhydrous OPCs (Jansen et al. 2011a) and to OPC pastes (Jansen et al. 2012a,b).”
Very early-age reaction kinetics and microstructural development in alkali-activated slag (2015, background): “3 have already reported, involves distinct dissolution, induction, acceleration, deceleration and steady state diffusion stages, which are apparent from the heat evolution curve [22—25].”
Calcined clay – Limestone cements: Hydration processes with high and low-grade kaolinite clays (2021, background): “This higher cement hydration heat can be partly attributed to the significant aluminate peak (Jansen et al. [55]).”
One-part geopolymer cement from slag and pretreated paper sludge (2018, methodology): “The calorimetric curves for all samples except GP1 are similar to the OPC heat of hydration stages (Jansen et al., 2012).”
Retardation effect of styrene-acrylate copolymer latexes on cement hydration (2015, methodology): “have intensively contributed to enable a better interpretation of the calorimetric data by following the time-dependent phase evolution during early hydration of cement using the technique of in-situ XRD [21,22].”
Rietveld quantitative phase analysis of Yeelimite-containing cements (2012, methodology): “The method was proposed by O'Connor and Raven [34] and very recently applied to anhydrous cements [35] and to pastes [36].”
Advances in understanding ye'elimite-rich cements (2019, result): “for calculating the hydration heat flow and the heat of hydration of ye'elimite-based systems, similar as previously done for Portland cement [206].”
Influence of limestone on the hydration of ternary slag cements (2017, background): “For the given C3A and sulphate 454 content, which was kept identical among the composite cements investigated, similar 455 sulphate depletion points [45] would be expected.”