Highly Efficient Broadband Continuous Inverse Class-F Power Amplifier Design Using Modified Elliptic Low-Pass Filtering Matching Network

By Mengsu Yang, Jing Xia, Yan Guo, Anding Zhu. IEEE transactions on microwave theory and techniques, 2016

142 citations recorded by the source corpus.

This paper proposes a design approach for a broadband and high-efficiency continuous inverse Class-F (CCF-1) power amplifier (PA) based on a modified elliptic low-pass filtering (LPF) matching network (MN). From theoretical and practical perspectives, the importance of a swift impedance transition from the higher end of the fundamental frequency band to the lower end of the second harmonic band is discussed, when designing a broadband single-mode PA. After being compared with widely used Chebyshev LPF MNs, a modified elliptic LPF MN, which provides a sharp roll-off, is utilized to provide the required rapid transition. A step-by-step design procedure of the proposed modified elliptic LPF MN is presented. Experimental results show that a high-efficiency CCF-1 PA is realized from 1.35 to 2.5 GHz (fractional bandwidth = 60%) with measured drain efficiency of 68%-82% and output power of 41.1-42.5 dBm. When stimulated by a 20-MHz LTE signal with an average output power of approximately 34.5 dBm, the proposed PA, combined with digital pre-distortion, achieved adjacent channel leakage ratios (ACLRs) below -45 dBc, with average efficiency (AE) ranging from 37% to 45.8%. Similar performance is measured when the proposed PA is driven by a dual-band dual-mode modulated signal with a 100-MHz instantaneous bandwidth at a center frequency of 2.14 GHz.

Subfields: Electrical and Electronic Engineering

View Paper: https://www.semanticscholar.org/paper/28e4bed216fe7508f2e5a0255f33380d764a0b93