Analysis and evaluation of bondline thickness effects on failure load in adhesively bonded structures

By D. Gleich, M. V. van Tooren, A. Beukers. 2001

244 citations recorded by the source corpus.

Subfields: Civil and Structural Engineering, Mechanics of Materials

View Paper: https://www.semanticscholar.org/paper/20c9cb425c2341c7427d30194425eca840c1de7f

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Civil and Structural Engineering

1. I. Villegas
2. M. Shahverdi

In Mechanics of Materials

1. I. Villegas
2. P. Mitschang
3. H. Bersee
4. Khaled M. Yassin
5. M. Hojjati

Citations in the corpus

• Strength development versus process data in ultrasonic welding of thermoplastic composites with flat energy directors and its application to the definition of optimum processing parameters (2014, background): “8 bondline thickness on the strength of adhesive bonded joints [21], the decrease in the thickness of the weldine can be expected to reduce to a certain extent the peak stresses at the edges of the overlap in single-lap joints and hence to contribute to the increase of the apparent lap shear strengt”
• Process and performance evaluation of ultrasonic, induction and resistance welding of advanced thermoplastic composites (2013, background): “It is well known that the peel and shear stress concentrations occurring at the edges of the overlap in single-lap shear tests are very sensitive to factors such as joint geometry (taper, fillet and bondline thickness) or the stiffness of bondline and adherends.(30,31) Consequently, the analysis of ”
• Optimum adhesive thickness in structural adhesives joints using statistical techniques base on Weibull distribution (2010, unknown): “[23] and da Silva et al.”
• A review on failure theories and simulation models for adhesive joints (2021, background): “Other possible reasons for decreasing strength in thicker bondlines might be identified in the more pronounced adherend bending due to load misalignment, or interface adhesive-adherend stresses .([45,46]) Therefore, in order to realistically predict failure loads, analytical models should include th”