Wear assessment of Al/Al2O3 nano-composite surface layer produced using friction stir processing
By A. Shafiei-Zarghani, S. Kashani-Bozorg, A. Z. Hanzaki. 2011
149 citations recorded by the source corpus.
Subfields: Materials Chemistry, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/1dc59204fb6d3e01d74ca41233ffc559d5892def
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Materials Chemistry
- G. Agnihotri
- N. Yuvaraj
- D. Koli
- R. Purohit
- Sachin Maheshwari
- Arshad Noor Siddiquee
- Sandeep Rathee
- S. Aravindan
In Mechanical Engineering
- G. Agnihotri
- N. Yuvaraj
- D. Koli
- R. Purohit
- Sachin Maheshwari
- Arshad Noor Siddiquee
- Sandeep Rathee
- S. Aravindan
Citations in the corpus
- Issues and strategies in composite fabrication via friction stir processing: A review (2018, methodology): “During the last decade, the most commonly used reinforcement technique (refer Table 2) is the groove technique [85, 96, 117].”
- Fabrication of Al5083/B4C surface composite by friction stir processing and its tribological characterization (2015, background): “[42] have reported that nano size alumina particles are more uniformly distributed in the aluminum matrix due to increasing the number of FSP passes.”
- A Review on Properties, Behaviour and Processing Methods for Al- Nano Al2O3 Composites (2014, methodology): “Due to stirring action of the pin tool, metal flows to its back side where it is extruded/forged, consolidated, and cooled under hydrostatic pressure conditions Shafiei-Zarghani et al. (2011) used an A6082 commercial Al–Mg–Si alloy extruded bar as the substrate material.”