A split and recombination micromixer fabricated in a PDMS three-dimensional structure

144 citations recorded by the source corpus.

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

Current methods for characterising mixing and flow in microchannels (2010, methodology): “Due to the relatively simple experimental set-up, there are a number of studies reported in the literature (see for example: Hessel et al. (2003); Wong et al. (2004); Schönfeld et al. (2004); Lee et al. (2006)) that characterize mixing in micromixers via the visualisation of coloured dyes.”
A Review on Mixing in Microfluidics (2010, methodology): “[36] proposed to use steps and partition blocks on the bottom wall of the channel (Figure 19) to establish the split-and-recombination function without fundamental difficulty in the fabrication process.”
Shrinkage ratio of PDMS and its alignment method for the wafer level process (2007, methodology): “Applying this design offset, a 3D PDMS structured microchannel was fabricated, whose width and length are 400 lm and 12 mm, respectively, as shown in Fig. 5 ( Lee et al. 2006 ).”