Buck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy Harvester
By É. Lefeuvre, D. Audigier, Claude Richard, Daniel Guyomar. IEEE transactions on power electronics, 2007
445 citations recorded by the source corpus.
Subfields: Biomedical Engineering, Electrical and Electronic Engineering, Mechanical Engineering
View Paper: https://www.semanticscholar.org/paper/0e9c9946293017c696d3b49cc903616836294660
How researchers see this paper
The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.
In Biomedical Engineering
In Electrical and Electronic Engineering
In Mechanical Engineering
Citations in the corpus
- Design and Optimization of a Tubular Linear Electromagnetic Vibration Energy Harvester (2014, background): “Since the dc/dc charging circuit can be modeled as a resistive load under moderate assumptions [8], [25], the results with a resistive”
- Recent progress in blue energy harvesting for powering distributed sensors in ocean (2021, background): “So far, most of the research concentrated on the signal conditioning circuit, and energy harvesting has not received adequate attention [117, 122, 150-153].”
- Wind Induced Vibration Control and Energy Harvesting of Electromagnetic Resonant Shunt Tuned Mass-Damper-Inerter for Building Structures (2017, methodology): “Further, Figure 1(a) also shows the configuration of ERS-TMDI for the MDOF, where the ERS-TMDI is obtained by replacing the original energy dissipative damping cT in classical TMD with an electromagnetic transducer shunted with a resistance R, capacitance C, and inductance L [16, 39], and an inertan”
- Low-Power Design of a Self-powered Piezoelectric Energy Harvesting System With Maximum Power Point Tracking (2012, background): “The self-powered management circuits in [21] and [22] give up dynamic impedance matching in favor of power reduction of the driving circuit to several microwatts.”
- Broadband piezoelectric power generation on high-energy orbits of the bistable Duffing oscillator with electromechanical coupling (2011, background): “Therefore, the feedback sent from the electrical domain to the mechanical domain due to Joule heating in the resistor or due to more sophisticated harvesting circuits [35–40] is not expected to suppress the resulting strongly nonlinear phenomena”
- A review of energy harvesting using piezoelectric materials: state-of-the-art a decade later (2008–2018) (2019, methodology): “If this is the case, a buck-boost converter, which combines the functionality of both the buck and the boost converter, may be employed [291].”
- Resistor Emulation Approach to Low-Power RF Energy Harvesting (2008, methodology): “A similar example using a buck-boost converter is given in [26].”