Change in microstructure of selectively laser melted AlSi10Mg alloy with heat treatments

By N. Takata, Hirohisa Kodaira, Keito Sekizawa, Asuka Suzuki, M. Kobashi. 2017

500 citations recorded by the source corpus.

Abstract In the present study, we examined changes in the microstructure and mechanical properties of AlSi10Mg alloy, initially fabricated using selective laser melting (SLM) combined with a powder-bed system, by applying heat treatments at temperatures of either 300 or 530 °C. The as-fabricated samples exhibited a characteristic microstructural morphology and {001} texture. Melt pools corresponding to the locally melted and rapidly solidified regions were found to be composed of several columnar α-Al grains surrounded by fine eutectic Si particles. A fine dislocation substructure consisting of low-angle boundaries is present within the columnar α-Al grains. At elevated temperatures, fine Si phase precipitates within the columnar α-Al phase and coarsening of the eutectic Si particles occurs. These fine Si particles inhibit grain growth in the α-Al matrix, resulting in the microstructural morphology and [001] texture observed in the heat-treated samples. The dislocation substructure disappears in the columnar α-Al grains. Furthermore, the formation of a stable intermetallic phase occurs, reaching microstructural equilibrium after long-term exposure. The as-fabricated specimen exhibits a high tensile strength of approximately 480 MPa. The strength is independent of the tensile direction, that is, normal and parallel to the building direction. In contrast, the tensile ductility is found to be direction-dependent, and is therefore responsible for a fracture preferentially occurring at a melt pool boundary. The direction-dependence of the tensile ductility was not found in the specimen that had been heat-treated at 530 °C. The present results provide new insights into the control of the direction-dependence of the tensile properties of AlSi10Mg alloys fabricated by SLM.

Subfields: Automotive Engineering, Mechanical Engineering

View Paper: https://www.semanticscholar.org/paper/036abeda2a178d33b0a8895c6838520f20491080

How researchers see this paper

The researchers whose trusted networks rank it highest, strongest advocate first. Every researcher gets a different order.

In Automotive Engineering

In Mechanical Engineering

Citations in the corpus

Review of Powder Bed Fusion Additive Manufacturing for Metals (2021, unknown): “AlSi10Mg [281,282,303] Laser 14–317 Columnar/Equiaxed α + Al-Si eutectice 220–230 (z) 250–280 (xy) 340 (xy) 320 (z) 1–5 (z) 1.”
3D printing of Aluminium alloys: Additive Manufacturing of Aluminium alloys using selective laser melting (2019, methodology): “[130] showed that the AlSi10Mg vertical samples also tend to have lower yield strength.”